Seco-larm Enforcer 3 Zones Alarm Pager System

Immediately receive notifications when your security system is triggered by setting up the Seco-Larm Enforcer 3-Zone Alarm Pager System with Vibrating Receiver. This complete alert system includes a transmitter that connects to almost any security system and a wearable pager that receives alerts from the transmitter. When your system is breached, the pager vibrates, sounds an audible alarm, and lights a colored LED to alert you.

• Belt-clip receiver vibrates and sounds audible alarm
• Color LEDs indicate which zone was activated
• Transmitter has 1 positive and 2 negative trigger inputs
• Receiver stores the last six pages for easy recall
• Low battery and unattended page indicators

The transmitter connects to almost any type of security control panel, vehicle alarm system, or other monitoring system. It features three instant trigger inputs – one positive input for +12V outputs and two negative inputs for ground outputs. When any of these inputs is activated, the transmitter will trigger the receiver, which will alert you and light the input's corresponding LED indicator (Green, Orange, or Red).

Expandable System

As a code-learning receiver, the vibrating pager can be programmed to receive signals from up to three different transmitters, allowing you to monitor up to three zones within a half mile of the receiver. Additionally, each transmitter can signal an unlimited number of receivers, so multiple users can receive alerts. (Extra transmitters and receivers are sold separately). More than two million possible coding combinations help ensure that the system cannot be tampered with by unauthorized users.

Backup Memory

Designed for reliable, continuous operation, the receiver features EEPROM memory that stores transmitter codes for up to one year without power. The battery-powered receiver also has a low battery indicator to alert you when the batteries need to be replaced.

Contents

• Transmitter
• Paging Receiver (E-37RV)
• (3) Mounting Screws
• Radio Antenna Adapter Cord

NOTES:

1. The system requires an antenna (sold separately). Seco-Larm offers an external antenna, Model E-37ANT. The system also works with a CB antenna, or a car AM radio antenna when used with the included Radio Antenna Adapter Cord.
2. Batteries not included.

Transmitter

• Number of Codes: Over 2 million (factory pre-set)
• Power: 12VDC
• RF Output Power: 4W max.
• Current Drain
• Standby: 10mA
• Active: 1A
• Frequency: 27MHz
• Antenna Impedance: 50 Ohms
• Range: Up to 1/2 mile in open air
• Dimensions: 4-1/8 x 3-1/8 x 15/16 inches (105 x 79 x 33 mm)
• Weight: 5.1 ounces (145g)

Receiver

• Number of Codes: Learns up to 3 transmitter codes
• Power: 3VDC (2 AAA alkaline batteries, not included)
• Battery Life: Approx. 1 month
• Current Drain
• Standby: 1mA
• Active (Beep): 20mA
• Active (Vibrate): 50mA
• Dimensions: 3 x 2-1/8 x 5/8 inches (76 x 54 x 16 mm)
• Weight: 1.6 ounces (45g) (without battery)

Technical Details

• Manufacturer Part No: E-37EV